Fanuc M6B Question - CNCzone.com-The Largest Machinist Community on the net!

Doug_M · #1 02-09-2010, 06:58 PM

I run a 1983 Mori Seiki MH40 HMC at work with a Fanuc M6B controller . When inputting data manually e.g. punching a program into the machine by hand I cannot find any button that acts as a shift key. There are keys with 2 different letters or a letter and a symbol on them so it would seem there has to be a shift key or a button that acts as one somewhere . Any help would be appreciated.

guru · #2 02-09-2010, 07:41 PM

Just keep pressing the key and watch the characters change

Doug_M · #3 02-18-2010, 05:42 PM

nope that didn't work .

f-bu · #4 02-19-2010, 01:57 PM

ABS/INC in the upper left corner. It can be denied by parameter, 308.6, check and set to 1 if it is zero.

Doug_M · #5 02-19-2010, 05:20 PM

Thanks I'll give that a try on Monday .

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fanuc 31i question	Apollopeon	Canadian Club House	2	12-09-2009 12:56 AM
FANUC OM question	allmetalcnc	Fanuc	1	12-18-2007 06:10 PM
Question about Fanuc OM Please help me as soon as possible	cristalex_it_sr	Fanuc	37	06-14-2006 02:24 PM
Fanuc 0M G00 Question	Uncle Buck	Fanuc	5	06-08-2006 03:25 PM
Fanuc 6t question	max_c	General Metal Working Machines	2	10-14-2004 04:56 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)