| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
02-07-2010, 09:55 PM
| |||
| |||
| Never heard about it. At least it is not there on 0i series. G7.1 is of course there, for cylindrical interpolation.  |
|
#3
02-07-2010, 11:38 PM
| ||||
| ||||
| It interpolation described in Fanuc 10T manual. And description says a feed is changed sinusoidally along hypothetical axis.
__________________ Soviet ICs are the largest ICs in the world!!! ))) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| vr-11 A & B interpolation | tarponicus | Haas Mills | 1 | 11-05-2008 03:48 PM |
| Hypothetical Taig Servo Setup | Burn | Taig Mills & Lathes | 8 | 09-05-2006 05:41 AM |
| Hypothetical 2 stroke v-8 | jrc347 | I.C. Engines | 25 | 06-15-2006 07:16 PM |
| Hypothetical 1 axis 3977 board | pminmo | Open Source Controller Boards | 12 | 04-14-2005 03:41 PM |
| interpolation | rimcanyon | General Electronics Discussion | 9 | 04-08-2004 01:10 AM |
| | |
Linear Mode
