Need Help!- Spindle cannot Rotate (Fanuc 11T-Dainichi)

[nastek]

Hi Guys,
On my last post (Fanuc 11T Start up error), problem fixed.
but now i have some problem "again".
Spindle cannot rotate when i give command M3/M4 S... on MDI mode.
On the operator panel, spindle drive can operate in auto/manual by toggle switch.
If i give command on MDI and Spindle drive in manual mode, spindle can rotate by manual speed override.
now the machine can working only in manual spindle, and i always adjust the spindel RPM with manual override.
please somebody help me to solve this problem.
(sorry for my english)

Nastek

[guhl]

Kind of I faced with the same problem when forgot enter all data tables into PMC parameters

[fanuc-support.c]

Check the PMC and PMC parameters. Ask the machine tool builder if they have the originals. Then compare with yours. Do notchange anything without knowing what it does.

[nastek]

Thanks Buddy, i'll try to check one by one.

[fanuc-support.c]

If you have electronic copies of both, there are text comparison programs you can download off the net. That's what i use to compare NC parameters.