copy program on fanuc series O or OT - CNCzone.com-The Largest Machinist Community on the net!

cuz1007 · #1 01-24-2010, 12:07 PM

I would like to know how to copy a program from the library and then give that program a different program # so that edits can be made. I read the manual over and over again but cant find the soft key ex-edit I can do this on the series 16 or 18 fanuc but on the series O i'm stumped. This would save alot of time not having to get the laptop and downloading that way, any help would be appreciated.
thanks

dcoupar · #2 01-24-2010, 01:19 PM

You need the EX-EDT (Extended Edit) option.

If you go to EDIT mode, press PRGRM , then press the > soft key you will see EX-EDT if the option is turned on.

cuz1007 · #3 01-25-2010, 06:23 PM

ex-edit soft key will not appear, must be turned off, any way to turn this option on??? fanuc series o thanks

fanuc-support.c · #4 01-26-2010, 05:26 AM

You have to buy the option from Fanuc. Or google the correct words.

guhl · #5 01-27-2010, 12:57 PM

PM sent
only for 0 series
not for 0i series

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fanuc Series 15-M Trouble uploading Ladder Program	grege101	Fanuc	5	12-13-2007 09:38 PM
Series I with Heidenhain 155 Won't run program	dbcooper99	Bridgeport and Hardinge Mills	13	10-16-2007 01:56 PM
Need option bit for Fanuc 15M to to copy programs	Factory Guy	Fanuc	2	01-24-2007 02:03 AM
Copy Program Section?	donl517	Milltronics	5	10-30-2006 05:47 PM
Series 1 Standard remanufacture program	seanm8966	CNCzone Club House	3	11-08-2005 04:05 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)