| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-20-2010, 10:10 PM
| ||||
| ||||
fanuc 16i on a doosan dhp 400 when i turn g08 p1 on the machine will cut smaller arcs as the feed rate increases although it will accelerate smoothly and it dosent jerk. it like its not using the arc radius based feedrate clamp which does work properly in the non look ahead control mode does anybody know if there is a parameter i need to change or even if the look ahead control mode is supposed to support the arc radius feedrate clamp?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Look Ahead Control Disabled | laser jim | G-Code Programing | 4 | 06-12-2009 12:35 PM |
| Need Help!- Having problems cutting arcs with Fanuc 11M | carlosdcerna | Fanuc | 6 | 04-20-2009 12:28 PM |
| Cutting arcs and circles | inaman | GibbsCAM | 4 | 04-26-2008 02:04 PM |
| Cutting circles and arcs | Hack | General Electronics Discussion | 4 | 11-08-2004 03:12 PM |
| Cutting !@#$% Arcs... | Joe Petro | General CAM Discussion | 5 | 01-12-2004 08:17 PM |
| | |
Linear Mode
