Need Help!- Fanuc 0M with PMC M

[M.RISHIKESH]

Good Morning to u all Sirs,

We r having a HMC with Fanuc 0M having PMC M board in it.

As u all r aware, this board has got 2 EPROMs (27C256) OF1 & OF2 in it.

Thro S4 dataman i could take back up of these two EPROMs, now i want to see this in Fladder.

Pl advice and let me have Fladder which can support PMC-M so that i can open the PMC in it

I am having Fladder Version 3.0 but when i am opening up in Windowsx XP, some unwanted characters are coming over F1, F2 keys etc so i feel this version which i am having is not compatible with Windows XP

Pl reply at maddala.rishikesh@tatamotors.com

Pl also advice if Fladder which wud support PMC M wud open up only in DOS (Windows 98)

Best Regards,

M. Rishikesh

[MysticMonkey]

you must install ansi.sys driver device to your

windows\system32\config.nt

alter this file to look like this

dos=high, umb
device=%SystemRoot%\system32\ansi.sys
device=%SystemRoot%\system32\himem.sys
files=40

that will get it working

[ker2008]

Originally Posted by M.RISHIKESH Good Morning to u all Sirs, We r having a HMC with Fanuc 0M having PMC M board in it. As u all r aware, this board has got 2 EPROMs (27C256) OF1 & OF2 in it. Thro S4 dataman i could take back up of these two EPROMs, now i want to see this in Fladder. Pl advice and let me have Fladder which can support PMC-M so that i can open the PMC in it I am having Fladder Version 3.0 but when i am opening up in Windowsx XP, some unwanted characters are coming over F1, F2 keys etc so i feel this version which i am having is not compatible with Windows XP Pl reply at maddala.rishikesh@tatamotors.com Pl also advice if Fladder which wud support PMC M wud open up only in DOS (Windows 98) Best Regards, M. Rishikesh

PL send your 0e1 0e2 ( 0f1 0f2) to me , i can help you !
i have a software can convert 0e1 0e2 ( 0f1 0f2) to *.#ex .
my e-mail : kele225 @ vip.qq.com