Need Help! Ladder Help - CNCzone.com-The Largest Machinist Community on the net!

Scottjit · #1 11-20-2009, 11:03 AM

I have tracked down that the R90.1 is causing my alarm. From the picture I do not understand what is in the box that is causing this alarm. I think it is in the data table for the tools. Not sure what the "DSCHBSUB34" is. Please Help.

greenery_fr · #2 11-20-2009, 12:17 PM

Hope it will help

RST reset

RST=0: RELEASE RESET
RST=1: RESET W1="0"

Activaction command

ACT=0 do not execute DSCHB instruction. W1 dose not change
ACT=1 Execute DSCHB . If the search data is found,table number where the data is store will be output .If the search data is not found ,W1 become 1

Regards

f-bu · #3 11-21-2009, 04:16 AM

The tool number you are looking for does not exist in the data table - check again the table for missing tool numbers, duplicated ones, zeroes etc.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
For QTS-200 Ladder	yepingapple	Mazak, Mitsubishi, Mazatrol	5	06-16-2009 10:21 PM
18T Ladder changes	CNC Solute	Hyundai Kia machine	8	01-30-2009 07:04 AM
Need Help!- ladder	hongjianming	Fanuc	4	01-22-2009 08:45 AM
Ladder on 0T	guhl	Fanuc	4	08-17-2008 10:15 PM
PMC-LADDER	CHANDRU	Fanuc	2	12-13-2007 09:17 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)