| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-04-2009, 09:16 AM
| |||
| |||
Hi, All I have a Ikegai With a fanuc 6T Control. DC spindle Drive No. A06B-6041-H106. The control power fuse F4 blows after the spindle runs for a short time. Anybody out there have experience with this problem? What do you think would be the most likely cause for this to happen? Thanks, jerry  |
|
#2
11-04-2009, 09:37 AM
| |||
| |||
Since I don't have prints in front of me, my guess would be the spindle motor fan is bad. |
|
#3
11-04-2009, 10:56 AM
| |||
| |||
| Thanks for the reply underthetire, I'll give that a look see. Jerry |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| harbor freight 7x10,fuse blown,not working | fpm | Mini Lathe | 2 | 06-20-2009 06:06 PM |
| Fanuc Power Supply Internal Fuse Blown | hrhoward | Fanuc | 1 | 01-07-2009 03:42 PM |
| Problem- 0.6 amp fuse blown | highspeedmazak | Tormach PCNC | 2 | 09-05-2008 11:11 AM |
| Problem- fanuc spindle fuse on dc link blown | Nastyzen | Fanuc | 4 | 08-28-2008 10:05 AM |
| Yaskawa AC Spindle Drive problems...blown? | nlh | Servo Motors and Drives | 0 | 08-04-2006 07:19 AM |
| | |
Linear Mode
