Need Help! T-14 -IB ROBODRILL WITH PALLET CHANGER - CNCzone.com-The Largest Machinist Community on the net!

sawdaddy2003 · #1 10-09-2009, 06:18 AM

i had a zrn alarm and fixed the problem that caused them....Now how do i get the machine to its original machine 0 or what do i need to do to establish where? How do i know the pallet changer will not crash? controls are 16i-m fanuc and machine is T-14 -IB ROBODRILL WITH PALLET CHANGER

fanucman · #2 10-09-2009, 02:14 PM

call methods?

sinha_nsit · #3 10-10-2009, 09:21 AM

Again Absolute vs. incremental encoder issue.
If it is absolute, the previous position is lost and you have to repeat the measurements.

But, I am no expert. I just made a guess!

dcoupar · #4 10-10-2009, 10:24 AM

The only way I know to do it is physically move the machine to it's zero position then toggle 1815.5 and 1815.4 off, cycle power and toggle both back on.

nakatome · #5 10-12-2009, 01:27 PM

on robodrill you have quick nc key ,on quick side you have soft keys chose maints, under
maints chose axis orgin pick axis follow screen prompt

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- VF3 Pallet Changer Problems	j-radkemachine	Haas Mills	1	03-10-2009 11:00 AM
Pallet Changer	MIDDEN300	CNC Machining Centers	5	09-20-2008 08:32 AM
Pallet Changer for a Fadal	Delw	Fadal	5	05-16-2008 09:10 AM
VF-3 & Pallet Changer	big_mak	Haas Mills	14	10-12-2007 02:00 PM
Automatic Pallet Changer	DDM	CNCzone Club House	4	10-07-2004 10:22 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)