SV009 and SV011, Fanuc 11M - CNCzone.com-The Largest Machinist Community on the net!

kadettevo · #1 09-22-2009, 03:36 PM

Have got a problem on my mill, Fanuc 11m, M-series servo (DC), suddenly on power up i got SV009 and SV011 on X-axis, no way resting it either.. it just try to power up again and same fault appears..

Does any one have a clue??

Master PCB digital display says "1" and no error on the servo amps.

Have check the motor, everything looks ok, coal, and wires.

memoryman · #2 09-23-2009, 08:05 AM

your master pcb is probably defective. First check your servo parameters.
Use the maintenace manual pages 98...
Bill

yours_prabhat · #3 09-23-2009, 12:05 PM

reset the servo setting of machine If problem persists feel free to communicate me on prabhatmishra@mail.com

juguala · #4 08-25-2011, 09:49 AM

SV 000, SV009 and SV009 on Fanuc 11M series. These alarms are generated on Z axis.
Check feedback cable, OK. Motor not too hot. Need help please.

J.O.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GE Fanuc & FANUC proprietary posts	CNCadmin	Fanuc	44	01-05-2012 08:54 AM
FANUC & GE FANUC Repairs	RRL	Product Announcements & Manufacturer News	1	04-17-2011 11:50 AM
can fanuc ac digital servo amplifiers be run by a controller other than fanuc?	js412000	Servo Motors and Drives	5	03-09-2011 09:11 AM
Fanuc & GE Fanuc Repairs	RRL	Product Announcements & Manufacturer News	0	10-01-2008 12:42 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)