help!

[mohammad reza]

Dear all workmate,
I had problem (ram parity error),then reset it and enter all of parameters and parameter nc/pc as keeprle ,data is....now first setup is good,but when enter spindle code S500 M03 start it rotation too slow, i think don't enter parameter spindle.I dont know do it?
my machine is kuraki milling fanuc 10m.
please help me

[John_B]

Mohammad,

I have my parameter list you could refer to, but I believe the spindle parameters are pretty specific to each set-up. It may of some help though. Send me your e-mail address via PM and I'll send you the file back.

[mohammad reza]

Originally Posted by John_B Mohammad, I have my parameter list you could refer to, but I believe the spindle parameters are pretty specific to each set-up. It may of some help though. Send me your e-mail address via PM and I'll send you the file back.

mr_ghorbani_tari@yahoo.com
Thank you

[mohammad reza]

Originally Posted by mohammad reza mr_ghorbani_tari@yahoo.com Thank you

my friend, have you electrical catalog fanuc 10M?
If you have send me.

[John_B]

Parameter file sent. I don't have the electrical schematic or parts list for this control. Sorry.