| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-30-2009, 05:55 PM
| |||
| |||
Dear All, on a center lathe "Biglia" with Fanuc 21i, when power up only "60M5-04" displayed and then " graphic......." for less than a second appears. i can not access the system boot, and on the motherboard one red led "Sfail" is on and the 4 green leds are on. could any one help. sting  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Alarm 24 displayed on spindle drive - not ready | maxvic | Fanuc | 4 | 06-28-2009 05:44 AM |
| Help, Part displayed upside down? | bcnc | Mach Mill | 3 | 11-22-2007 02:11 PM |
| Pitch error compensation parameters not displayed | sab | Calibration & Measurement | 1 | 07-10-2007 01:10 PM |
| More power from switching power supply | R.thayer | General Electronics Discussion | 4 | 03-10-2007 07:03 PM |
| | |
Linear Mode
