Alarm 24 displayed on spindle drive - not ready

[maxvic]

My machining center kicked into "not ready" mode mid part and eveything stopped. I reset and when I zeroed all axis X and Z moved in rapid but my Y moved very slowly and shot past home and kicked the Y axis over travel, I shut down and tried agian and it homed OK but then shortly thereafter not ready kicked on and it would not reset I opened up the back cabinet and there was a AL 24 displayed on the LED on the spindle drive Is the spindle alarm somehow related to a Y axis homing problem - home switch stuck on? - this thing is a Fanuc OM. Any help is greatly appreciated.
maxvic

[avtechmachine]

AL-24 is the serial communication data between the CNC and Spindle amplifier, I think your should look into the Y axis decel switch and may be the broken wire to the decel switch
Ahn Vuong

[maxvic]

Thanks Ahn Vuong - I will look and see.

Maxvic

[yours_prabhat]

disconnect the Y axis and re connect all the cables. The AL 24 will be disappear check the communication between drives and communication cable

[maxvic]

Thanks, I will check next week and let you know.