Need Help! Turning On Mirror Image Fanuc 18-m Control - CNCzone.com-The Largest Machinist Community on the net!

PICMAN · #1 06-23-2009, 08:49 AM

Pleaaseee Help Me Figure Out How To Mirror Image X & Y To Flip My Axis.......

dcoupar · #2 06-23-2009, 10:30 PM

You should be able to go to OFFSET/SETTING, then [SETING] cursor to the axis you wish to mirror and change the 0 to 1.

davisboys · #3 06-27-2009, 03:41 PM

I tried to turn on mirror image a couple of ways, I maybe think there is also a parameter you can change which does the same thing, but had no luck with either method. The machine mfg. support rep didn't understand it either.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MIRROR IMAGE WITH MY FANUC 18-M	PICMAN	Fanuc	3	08-04-2009 08:10 PM
mirror image	cp465vw	Machines running Mach Software	8	04-13-2009 10:39 PM
Need Help!- Mirror image	rbach	Mach Mill	0	01-19-2009 11:58 PM
Need Help!- Everything comes out as mirror image	rbach	Controller & Computer Solutions	4	12-20-2008 11:46 PM
MIRROR IMAGE HELP	TOM R	CNC Machining Centers	1	12-01-2008 02:01 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)