| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-18-2009, 06:27 AM
| |||
| |||
Can someone tell me how the 20 pin honda to db-25 cable is wired ..? This 20 pin honda connector plugs into M-5 on main board .....My db-9.....to db-25 plugs into this cable for programing........... Thanks for all your help.....  |
|
#2
06-18-2009, 07:11 AM
| |||
| |||
| Here is the pinout for the 20pin Honda conector on a 6series. I used this on my 10series control and it worked. This should be right however if you don't have the Oseries connection manual send a PM with your email and I will shoot it over to you. Stevo |
|
#3
06-18-2009, 07:50 AM
| |||
| |||
| Thanks ...I was realy looking for something that shows the 20 pin being connected to the M-5 on the main board ...This shows it going through a puncher interface card .......That the card plugs into main board ......thanks....GABEDRUMMIN@YAHOO.COM........... |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
