interchange BMUs boards on Fanuc 6M - CNCzone.com-The Largest Machinist Community on the net!

woonsteel · #1 05-28-2009, 09:49 PM

hi there
Currently I'm using BMU 64-2 A87L-0001-0016 05E and would like to get spare boards in case my current board goes off. Its hard to get the same coded board but i found others selling different BMUs listed below. Would it be possible to interchange/replace those BMUs to the Fanuc 6M motherboard ?

BMU 256-4 A87L-0001-0018 08G
BMU 1M-1 A87L-0001-0084 05B
BMU 256-1 A87L-0001-0017 05I

Thanks in advance

f-bu · #2 05-29-2009, 08:08 AM

These are just bigger, but the same old bubble memory. Check also prices for CMOS replacements, should be more reliable - there are Fanuc made, but also third parties, I remember memex.ca

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Just IN- Wanted Fanuc Servo Motors and boards	CNCMAN 83	Want To Buy...Need help!	1	07-07-2010 12:05 PM
Need Help!- Software to backup and interchange programs between different controls.	steelhead9	Machine Problems, Solutions , Wireless DNC, serial port	2	03-04-2009 07:02 AM
Interchange Chart for LM components	IQChallenged	Linear and Rotary Motion	1	11-30-2006 01:22 PM
Fanuc Circuit Boards ( PCB's )	mld	Fanuc	0	11-13-2006 09:52 PM
Fanuc boards	Hlynur	Fanuc	4	09-19-2006 09:17 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)