Need Help! small characters on 0T - CNCzone.com-The Largest Machinist Community on the net!

guhl · #1 05-19-2009, 06:59 AM

Hi
When I power the machine up position screen digits are unreadable and on rarameter and diagnostic screen digits are small. But letters are in normal size.

GPena · #2 05-19-2009, 11:20 AM

A similar thing happened to me once, the problem was the software. I just made a backup, burned in new eprom's and problem fixed.

You can try, good luck.

GP.

guhl · #3 05-20-2009, 02:13 AM

Thanks
I've fixed the problem, following your advise

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to have more than 32 characters in one block	sinha_nsit	Fanuc	3	04-01-2009 12:25 AM
Need Help!- Vibrating Characters on the CRT Screen	MetalZilla	Haas Lathes	2	08-22-2008 01:36 PM
Bad Characters	gplush	Haas Mills	5	02-08-2008 11:00 PM
Help with Optional Characters on the EOB Button	AZDEN	Fanuc	10	11-05-2007 11:20 AM
Number of characters in Tooltip	sanddrag	Suggestions for the CNCzone.com site.	1	05-24-2006 03:46 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)