change of "check image" 0M and 0T - CNCzone.com-The Largest Machinist Community on the net!

jeppes · #1 03-12-2009, 07:12 AM

How do I change the image in "check" from showing "Relative" to "Absolute"?

Now showing: (Relative), (Dist to Go), (G) as it shows on my 0-T

I want it to show: (Absolute), (Dist to Go), (G) as it does on my 0-M

I also want the same changed on my friends 0-M...

dcoupar · #2 03-13-2009, 01:34 AM

Parameter 0028 bit 0 = 1 displays the absolute coordinates on the program check screen.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MV 45 tool change "Help Please"	pattawit	Mori Mills	15	12-16-2008 03:02 PM
How to check "heartbeat" on BTC-1 computer?	Goslowjimbo	Bridgeport and Hardinge Mills	7	06-14-2008 06:28 AM
Programmable mirror image "15 mf"	cncwhiz	Fanuc	0	01-07-2008 03:42 PM
V2XT error message "DRIVE FAULT detected (0,z,y,x) check log"	rfdoyle	Bridgeport and Hardinge Mills	4	10-08-2007 03:35 PM
3D image "cracked" inside glass	moyesboy2	Glass, Plastic and Stone	17	08-04-2006 01:42 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)