0i parameter number for look-ahead feature - CNCzone.com-The Largest Machinist Community on the net!

sinha_nsit · #1 02-26-2009, 07:04 AM

What is the parameter number for controlling the look-ahead feature of the the control during program execution?

wujp · #2 03-02-2009, 09:26 AM

hi,
it has a lot parameters to setting .
you can use a fanuc software (servo guide) to fine-turning .
it can charge parameter online ,may be danger.
backup parameter first!
good luck !

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem- Look Ahead with G68	ludde_77	Fanuc	0	10-30-2008 05:13 PM
LOOK-AHEAD option	bfservice	Fanuc	1	03-05-2008 07:10 AM
Oi-mc Look ahead	SIG	Fanuc	6	10-02-2007 10:36 PM
I need a certain Parameter number (Fanuc OT)	M@T	Fanuc	1	08-22-2007 12:39 PM
look ahead on oi-mc	spock	Fanuc	2	05-03-2007 07:50 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)