Fanuc System P Model G

[drgbt]

Fanuc System P Model G I ran across one of these and it peeked my interest. When I power it up it says Fanuc but that’s all it does. Do you need software to make it do anything. What is it used for?

[BlueChip]

Hi ... this system is the "PC" based version of Fanuc's FAPT programming system that comes on controls like the 10TF and similar. It is basically a conversational ( fill-in-the-blank ) type programming creation system.

This system ... if my old man memory serves me correct ... requires 5.25 floppies to operate. I think the floppies may contain some of the "operating system"????

If that peeked your interest ... maybe take a look at our PC based conversational programming software KipwareT (turning) and KipwareM (milling) ... info and demos at www.KentechInc.com.

Real World Machine Shop Software at
www.KentechInc.com

[f-bu]

All the software for P-G is loaded from 5.25" disks. The P-G has only a boot loader on board. If you have got such a disk, put it in the left drive and hold "LOAD" for several seconds. There were different products running on it, like FAPT DIE for moldmaking, MILL and TURN for general programming, LADDER, ROM etc.etc.

[GPena]

Hi, I have a system P Mate model G, Fanuc number: A08B-0036-B001, with no floppy disks, do you have any idea where to get them???? Or, if someone has them please share a copy.

Thank you.

Greg.