| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-27-2009, 09:50 PM
| |||
| |||
I have recently pruchased a hartford with a fanuc 21i controller,it has some added software features in it from hartford.The aicc settings are entered with the hartrol software and called up with the standard g5.1 q1.BUT these figures are not being transfered into the aicc settings(1-10) to be activated by the g5.1 q1. instead i get an error of "5157 aicc setting zero" Can anyone help me?  |
|
#2
01-31-2009, 06:46 AM
| |||
| |||
| 5157 PARAMETER ZERO (AICC) (M series) Zero is set in the parameter for the maximum cutting feedrate (parameter No. 1422 or 1432). Zero is set in the parameter for the acceleration/deceleration before interpolation (parameter No. 1770 or 1771). Set the parameter correctly. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GE-FANUC 21i-t problem | Cole84 | Fanuc | 6 | 11-26-2007 03:44 AM |
| Fanuc OM-C pmc problem | rai | Fanuc | 17 | 10-29-2007 05:25 AM |
| Fanuc 21i-T DNC Problem | Stebedeff | Fanuc | 4 | 07-16-2007 03:00 PM |
| Fanuc 0M problem | bauhar | Fanuc | 6 | 09-11-2006 10:01 PM |
| Fanuc 5 problem | jevs | Fanuc | 3 | 02-21-2005 07:36 PM |
| | |
Linear Mode
