Problem Special Parameters Settings - CNCzone.com-The Largest Machinist Community on the net!

daewo 8HC · #1 01-23-2009, 09:50 AM

Dear CNC zone partners,

I'm looking for the special settings parameter of a Fanuc controller series OT model D. Somebody could help me with this problem? i had to clear the ram because the machine is disable to make any operation. Thanks

Al_The_Man · #2 01-23-2009, 09:54 AM

Do you mean the 900 option parameters or the general setup parameters, Both are unique to the machine as set by the MTB, you will either have to contact the MTB or post the make model if you are missing the parameters, in the hope someone has the same machine.
Al.

daewo 8HC · #3 01-23-2009, 11:35 AM

Thanks Al,

Yes, i'm looking for the 900's parameters. I have a copy of the data sheet where the special parameters are, however much of them are not visible. These are some datas about the controller:

Mark: Daewo Puma 8HC
Model: A02B-0098-B511
Serial Number: 0060550

Regards

davisboys · #4 01-26-2009, 06:00 AM

the "setting" page key and the "parameter" key take you to different places

mluqman · #5 01-30-2009, 05:28 AM

Hello everyone, FYI maybe this link could be useful http://cncfanuc.blogspot.com

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Mach3 CV settings vs. G-100 Plugin CV settings	Bfarn	Machines running Mach Software	7	12-17-2008 10:45 AM
parameters,settings	Michael82	Haas Lathes	1	11-19-2007 09:02 AM
Please list your most used settings and parameters	1ctoolfool	Haas Mills	2	10-12-2007 11:49 PM
Special CNC lathe	fiki	General Metal Working Machines	9	08-23-2007 11:29 AM
Need 'special' PSU...	WilliamD	General Electronics Discussion	4	09-25-2006 08:41 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)