anayak and 18-m fanuc

[trent2]

Hello all. new to this forum so hoping someone can help.

Recently installed a used ANAYAK mcv 5000 mill with Fanuc 18m controller. Both new to me. I keep getting a fault when running the machine in both MDI and Jog mode. there is no pattern to it, and not sure if it is machine or controller problem.

The fault is: 972 NMI occured in other module
slot 13 pc0 50 NMI SLC


Hoping someone can help
Thanks

[stevo1]

I have never seen this alarm before so I don't have anything to say on what to look for. However I have attached the alarm description from the book. Maybe it will help point you in the right direction.

Good luck,
Stevo