Fanuc 10M parameter list for Mori - Help please?

[John_B]

Does anyone have a 10M control on a Mori Seiki MV Junior that could send their parameters?

I have been unable to back-up these since I got the machine due to a faulty comm board (won't send - only receives), and thought I could just be careful and make it. Stupid, I know. I should have written them down.

Over the weekend it got real cold in my shop and the back-up batteries went dead - so the machine did too...

Best regards,
John

P.S. I've posted this on the Mori forum as well.

[greenery_fr]

Hello

Please send me you email I will send for you parameter

Regards

Does anyone have a 10M control on a Mori Seiki MV Junior that could send their parameters?

I have been unable to back-up these since I got the machine due to a faulty comm board (won't send - only receives), and thought I could just be careful and make it. Stupid, I know. I should have written them down.

Over the weekend it got real cold in my shop and the back-up batteries went dead - so the machine did too...

Best regards,
John

P.S. I've posted this on the Mori forum as well.

[John_B]

Back online. Thanks for the help! Best regards, John B.

[mkeoj]

John B,I also lost my parameters due to a bad board.We had backups.But turned out to be for former jr we had with a yasnac control.Could you please forward a parameter list.Thanks,Mike

[John_B]

Here is the file from the machine as we're running it now. I have a couple of small things to fine tune in the settings, but it's making chips right now - so I'll get to it later.

Hope this helps.
John B