| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-17-2008, 01:31 PM
| |||
| |||
Anyone have an idea why a fanuc 0T would give us a 005 error when we run this program; % O1000 POPEN DPRNT[CS] PCLOS M30 % The manual says: If this is an alarm, Program Errors -005- the Fanuc book says: No Data After Address - The address was not followed by the appropriate data but was followed by another address or EOB codes; modify the program. I am trying to get data to be sent out the RS232 port when this runs. Thanks in advanced for any help!
__________________ Greg Mercurio -Shop Floor Automations www.shopfloorautomations.com /619-461-4000  |
|
#2
12-17-2008, 03:08 PM
| |||
| |||
| This may not be a P/S alarm. Make sure that your 'edit enable' key is turned on. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fanuc Error 449 | dhiruj | Fanuc | 7 | 01-04-2009 12:18 PM |
| Need Help!- Fanuc OT Error 410 | jgj | Fanuc | 7 | 07-07-2008 12:08 AM |
| Help! Fanuc OT error. | ua6lfj | Fanuc | 9 | 09-16-2007 12:02 PM |
| SR 591 - TV error on Fanuc 10M???????Help! | John_B | Fanuc | 4 | 06-29-2007 11:38 AM |
| Fanuc 6MB Error LED | tsalpha | Fanuc | 4 | 01-05-2007 08:51 AM |
| | |
Linear Mode
