| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
11-25-2008, 04:10 PM
| ||||
| ||||
| I don't know the machine, but it is posted in the Fanuc forum so I assume it has a Fanuc controller. Rather than change the ladder, you could find the input that confirms the conveyor is started and place a jumper on that input, if you have the ladder diagram, it may show it. It is probably intended to monitor a N.O. contact on a motor contactor for e.g. Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E.  |
|
#3
11-25-2008, 07:02 PM
| |||
| |||
| just call clausing they are very good about helping your repair machines ask for mike in services they open at 8am eastern time Phone (269) 345-7155 |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chip conveyor for LB15 | cad01 | Okuma | 5 | 12-09-2011 10:11 PM |
| turbo microfine conveyor troubles | jlockw | Machine Problems, Solutions , Wireless DNC, serial port | 1 | 02-08-2009 09:46 PM |
| 640t nexus chip conveyor | Lost-one | Mazak, Mitsubishi, Mazatrol | 1 | 03-11-2008 11:27 AM |
| Swarf again.. | Tugiyana | Mastercam | 2 | 01-07-2008 02:00 PM |
| turbo conveyor wiring | theguild | General Electronics Discussion | 1 | 09-13-2006 08:41 PM |
| | |
message - swarf conveyor not started - 
The m/c is a colchester tornado 200 and does not have a swrf conveyor fitted, is there a way of turning this message off?
Linear Mode
