Need Help!- Fanuc OM

[Derek.C]

Hey guys , I made a big error today and pushed reset while I was powering up the machine and cleared my parameters , Now I was smart enough to back these up quite awhile ago .My problems starts with the machine will not let me load anything from the computer . So can anyone suggest to me how to properly clear the data and then reload my parameters so I can make chips again .
Thanks in advance .

[Al_The_Man]

Send me an email address via PM, I will send the procedure.
Hopefully you have the 900 parameters also!
Al.

[Derek.C]

The PM has been sent Al , Where do I find the 900 parametrs ?
If necessary I will copy them out by hand and install them

[Al_The_Man]

The procedure is sent.
The 900 parameters are usually supplied by Fanuc from factory on a tractor fed printer sheet.
You need this as this is the m/c options.
You just need to enter your RS232 parameters and then you can download to CNC.
Al.

[Derek.C]

So I will need to get the factory spects from Fanuc is what you are saying

[Al_The_Man]

Hopefully, yes.
Al.

[gabedrummin]

I think it would be inportant to let everyone know what machine this is as I have found that not all are created equal..................

[Derek.C]

Originally Posted by gabedrummin I think it would be inportant to let everyone know what machine this is as I have found that not all are created equal..................

I did not think that this was important since it was a control issue and not a machine specific issue .
The machine is a First CV 410 a very basic new in 1984 machine . No tool changer no programmable speed .

[padobranac]

When outputing parameters, you are able to punch out 900's parameters also by holding some key...am I right?

Now it is too late for you, but for the next time or for others....

[Al_The_Man]

Originally Posted by padobranac When outputing parameters, you are able to punch out 900's parameters also by holding some key...am I right? Now it is too late for you, but for the next time or for others....

Hold EOB then while push Output- Start.
Al.

[Derek.C]

What I was meaning was how do I access the 900 parameters to be able to reinstall by
manual input

[Derek.C]

Ok I have the 900 parameters reinstalled ( called the machine seller and got them over the phone ) . Everything works fine except the machine will not cycle start . This is also the case with MDI . I am confused the machine had no problems prior to me reseting the memory .