Need Help! FANUC 920 Watch Dog Timer system alarm - CNCzone.com-The Largest Machinist Community on the net!

spea · #1 11-16-2008, 06:44 AM

Fanuc O-TB not working and indik. how on picture .What can be problem ? Good Luck.

cncdiag · #2 11-16-2008, 06:00 PM

Looks like your battery is low and your memory is scrambled.
Power up the control holding in the "Reset" and "Delete" push buttons.
Then reload parameters.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- system alarm 904& bubble memory	sting	Fanuc	2	03-05-2008 04:17 PM
PMC system alarm	dalvinder	Machine Problems, Solutions , Wireless DNC, serial port	4	09-05-2007 08:28 PM
Set the counter & timer Fanuc OTB	hien100881	General CNC (Mill and Lathe) Control Software (NC)	1	09-25-2006 01:13 PM
System Alarm # 3	tedh	General CNC (Mill and Lathe) Control Software (NC)	6	07-25-2005 05:12 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)