LinkBack URL
About LinkBacks
Side to side is usually an indication the horizontal sync is going out or drifting.
Try the Horiz hold if one is labeled this way.
Al.
| | |
Lately, when I start up the machine the screen acts crazy for a few minutes. I can just leave it alone, and it eventually clears up. Looks like everything is moving from one side to the other. Is there an adjustment somewhere? I remember on those old TVs we had when I was a kid there were two knobs to adjust horizontally and vertically. Didn't they basically do the same thing?
Side to side is usually an indication the horizontal sync is going out or drifting.
Try the Horiz hold if one is labeled this way.
Al.
CNC, Mechatronics Integration and Custom Machine Design (Skype Avail).
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Would that be inside the control? There isn't anyhting on the front panel that says that. If it is going out, what can I do to fix it?
Usually it is due to a component drift due to aging, the horiz controls are near the high voltage, so take care when adjusting, the adjustment will in all likleyhood be inside.
Al.
CNC, Mechatronics Integration and Custom Machine Design (Skype Avail).
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
THAT HAPPENED TO ME BEFORE, IT FAILED IN THE MORNINGS AND AS SOON AS IS WARMED UP IT WORKED FINE, NO ADJUSTMENT WORKED. I HAD TO SEND THE MONITOR TO BE REPAIRED.
GP.
Where did you get yours repaired? I'm in trouble when this machine is down.
Posting Permissions
| | |
