I think the screen on my 6T is going out

[protrxrptr17]

Lately, when I start up the machine the screen acts crazy for a few minutes. I can just leave it alone, and it eventually clears up. Looks like everything is moving from one side to the other. Is there an adjustment somewhere? I remember on those old TVs we had when I was a kid there were two knobs to adjust horizontally and vertically. Didn't they basically do the same thing?

[Al_The_Man]

Side to side is usually an indication the horizontal sync is going out or drifting.
Try the Horiz hold if one is labeled this way.
Al.

[protrxrptr17]

Would that be inside the control? There isn't anyhting on the front panel that says that. If it is going out, what can I do to fix it?

[Al_The_Man]

Usually it is due to a component drift due to aging, the horiz controls are near the high voltage, so take care when adjusting, the adjustment will in all likleyhood be inside.
Al.

[GPena]

THAT HAPPENED TO ME BEFORE, IT FAILED IN THE MORNINGS AND AS SOON AS IS WARMED UP IT WORKED FINE, NO ADJUSTMENT WORKED. I HAD TO SEND THE MONITOR TO BE REPAIRED.

GP.

[protrxrptr17]

Where did you get yours repaired? I'm in trouble when this machine is down.