Procedure for BMU 6TA - CNCzone.com-The Largest Machinist Community on the net!

SGARCIAM · #1 10-25-2008, 09:15 AM

Does anyone know how to initialize a BMU for Fanuc 6 model A? I know how to initialize model B, so far not the same....

cncdiag · #2 10-25-2008, 12:38 PM

You can not initalize a BMU Board on a 6A control.
If you want to reinitalize your BMU put it on the 6B control to do this. Then put it back on the 6A and reload parameters

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Trumpf 2 hole Cat-Eye procedure	CLT-Tech	Laser Engraving & Cutting Machines	0	07-01-2008 09:33 AM
Mazatrol T1 Setup Procedure	mattme	Mazak, Mitsubishi, Mazatrol	4	07-23-2007 01:24 AM
Question on a procedure	gv71	OneCNC	3	06-13-2006 07:51 PM
Mazatrol M-1 - Initial procedure	lecamtu	Mazak, Mitsubishi, Mazatrol	5	07-23-2005 10:22 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)