Help With Organizing Fanuc Series

[stevo1]

Hey guys I am trying to consolidate all of my miscellaneous data that I have on all of the controls from standard parameters to option parameters. I need to know some of the proper ways to group this data. I hate it when I know that I have taken notes or have data for something and I spend hours trying to remember were I stored it or wrote it down. This is what I think is correct so far please correct me if I am wrong.
1. The 16/18/21T are the same on all parameters options
2. The 16/18/21M “” “”
3. The O-T “” “”
4. The O-M “” “”
5. Now I see on the manuals the 10/11/12 are the same. However I was unsure about the 15 control. I see that my option parameters are the same when I compare the 15 to the 10 except for the amount of options on the 10 go through 9124 and the 15 goes through 9147. Is the 15 included in this group? I assume that the T and the M in these series are different just like the 16/18/21 are.
6. Were do all the other series 3/5/6 ect. fall into place?
7. I also see that for the some of the options on the 16/18/21 if you subtract 9020 these are for the O series. Is there a similar way to determine for the 10/11/12/15 series?

Any input would be greatly appreciated as this is going to be a long process for me with all the data I have. I would like to start out organizing in the proper fashion before getting almost complete and finding out that I was wrong.

Stevo