| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-16-2008, 11:06 PM
| |||
| |||
I am having a problem going from one tool to the next with out going home after each tool operation. With this controls software, there is no tool geometry page. All tool coordinates are written into the program. There is a tool offset page. I have tried writing the program a few different ways, but the tools always end up in the wrong location. Any ideas on how this should be written?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Wasino w/ Fanuc 3T control | kz1670 | Controller & Computer Solutions | 0 | 10-09-2008 10:16 PM |
| gang tool holder | brucesu1 | Shopmaster/Shoptask | 8 | 04-22-2008 08:34 AM |
| C6 - Gang tool holder? | PEU | Syil Products | 0 | 04-14-2008 11:28 AM |
| Taig Mill converted to a gang tool lathe... | Anokiernan | Taig Mills & Lathes | 5 | 02-16-2008 04:10 PM |
| Gang tool cnc mini? | Call Maker | Mini Lathe | 6 | 03-26-2006 11:38 AM |
| | |
Linear Mode
