Fanuc O-MD prog ck display

[yoshi900]

(thanks to this forum, i was able to change the absolute display Z to show correctly with the tool height comp adjusted).

Now that the absolute pos is showing what I wanted, I am looking to see if anyone knows if there is a parameter that I can change to display the absolute position in program check.

When I go to program check while running a program, it will display like 5 lines of prog up at the top, lower left is relative position, lower middle is distance to go, and lower right is all the active G/M code.

The relative display is not what I want to display in this screen. If I can change it to show absolute position, then I would have all the info in one screen that I needed.

[padobranac]

That's it, bit #0 is the last on the right

EDIT: That is for 0-MC, I suppose it is same parameter on 0-MD

[yoshi900]

That did it.!

Thank you padobranac.

[padobranac]

I am glad to be able to help, not just beeing helped