moriseiki NT 4250 multitask machine

[Derek418]

Does anyone have an opinion on the moriseiki NT4250 with Fanuc controls,
we are looking at getting a new cnc, would like some feedback on this machine if possible? Cheers guys.

[mark46]

hi the mori is a very capable machine we use a twin spindle single turret
lathe with powered tooling , but also be aware that tool holders when running at top speed do get hot due to gears transfering angle of drive so point coolant nozzel at housing when running for log periods
regards m

[Derek418]

thank you very much, I get another question. currently we have a mazatrol integrex SY II, there are plenty of program written with mazatrol program. is there any ideas about converting them into Moriseiki NT series compatibale G-codes? thanks

[mark46]

thank you very much, I get another question. currently we have a mazatrol integrex SY II, there are plenty of program written with mazatrol program. is there any ideas about converting them into Moriseiki NT series compatibale G-codes? thanks

sorry i dont know of any quick way to convert mazak to fanuc , i have more experience with heidenhain 530i , fanuc and yasnac fanuc controls and there is no easy way to convert these either ,i am not familiar with mazak controls

mark