FANUC 15T Write Protect - CNCzone.com-The Largest Machinist Community on the net!

bmlw · #1 10-11-2008, 02:27 PM

Hello, maybe some of you FANUC experts could shed some light. I have finaly gotten back to my machine and things were looking good for startup. I have run in to a new problem. When I try to modify the parameters so that I can use the serial port for program loading I get the write protect message. I have found thet I need to modify Parameter 8000 - PWE to 1 to clear the write protect but have been unable to do so. The manual says to go to the settings screen, enter 8000, press the input number soft key and the paramater should display on the screen. This does not happen. Any Ideas? I have gone into the Service screen and can see the Parameter but am not able to change it there either.

Thanks in advance

Al_The_Man · #2 10-11-2008, 02:32 PM

Set mode to MDI.
Soft key: Settings, Chapter, General
go to P8000 push 1 enter.
Al.

bmlw · #3 10-11-2008, 02:47 PM

Thank a bunch. I will go and try it out right now

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Okuma howa tool geometry protect	chrisclegg	Okuma	0	10-10-2008 08:36 AM
Need Help!- Parameter write enabling on Fanuc OiT	hense	Fanuc	6	06-02-2008 05:26 AM
Anyone know where I can get a Program Protect key?	Billmac	Fanuc	11	04-14-2008 11:31 AM
kingston cnc lathe data protect key	m.amir	General CNC (Mill and Lathe) Control Software (NC)	0	10-02-2007 01:34 PM
Protect your G54...G59	jorgehrr	Fanuc	3	09-30-2007 07:11 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)