Programing for a Fedek DH-65 Brafeed

[squiz81]

I have just put in a fedek DH-65 bar feed onto a YCM GT200 lathe and can't seem to figure out how to get the barfeeder to reload a new bar. I have got it so that it will auto feed the bar when called by the lathe, but cannot get it to pick up a new length of bar. Any help? Suggestions? Programs?
Cheers

[gerrie]

I have just put in a fedek DH-65 bar feed onto a YCM GT200 lathe and can't seem to figure out how to get the barfeeder to reload a new bar. I have got it so that it will auto feed the bar when called by the lathe, but cannot get it to pick up a new length of bar. Any help? Suggestions? Programs?
Cheers

I HAVE AT THE END OF THE PROGRAM'
G4 X2.0
M CODE CHUCK OPEN
/M98P8000
G4 X2.0
M CODE CHUCK CLOSE
G4 X2.0
M99

P8000
G4 X2.0
M CODE CHUCK OPEN
/ M CODE BAR END SIGNAL
G4 X2.0
M CODE CHUCK CLOSE
G4 X2.0
M99

[ben_heinman]

Here are a couple pages that may help.

[gerrie]

Here are a couple pages that may help.

THANKS BEN WILL GIVE IT A GO

[Billet Sean]

I'm having the same issue with loading a new bar as well. Out turning center is a Viper lathe with Fanuc O-TD control. I've messed with all the proximity switches and they work, but it won't load a new bar... I'd use the little sub-program listed above but I don't know what the omitted M Codes for Loading the Bars are. Anyone know?
Thanks,
Sean