First post guys, someone might already of asked this one, but i searched and couldn't find it.
I've started work at a small engineering firm as a programmer, that has 3 Ikegai Lathe machines with Fanuc controls. 2 have the 0-T system, 1 has the 18-T.
On the 2 0-T machines, i have changed the parameter so enable angular turning (i.e G01 X50.0, A120.0 F.01 would put a 30' angle on the job), but i can't find the parameter to do it on the 18-T machine.
Anyone any ideas?? it'll save loads of time working out sizes for each job.
Cheers in advance