Need Help!- problem x axis

[jlviloria@gmail]

good evening,

I have a problem with the x-axis when you move in fast moving x only moves with a preview of 495mm/min that only happens in a positive sense

in advance thank you very much

jorge

[BKCOM]

What is your Fanuc model ?
Your machine is new machine or used machine?

[jlviloria@gmail]

FANUC 18MC
CENTER MACHINING HORIZONTAL
KIA H50
MODELO 2000
4 EJES
2 PALLETS

PARAMETERS WILL BE OR ELECTRONIC

[xavierdemoura]

Jorge,

Check if the signal X6.5 stay in 1. If yes, the limit switch of reference is active. You need fix that.

Daniel

[jlviloria@gmail]

friend thank you for your response,

BUT THE TRUTH not know WHERE CAN I SEE THE SIGNAL x6.5

Thank you in advance

JORGE

[g-codeguy]

Try SYSTEM, PMC, PMCLAD, type in X6.5, press Search. Don't know if you need the .5. I am only a lowly lathe programmer.

[xavierdemoura]

Jorge,

Like G-codeguy said, this is on way. But there is more one. PRESS SYSTEM > PMC > PMCDGN > STATUS. Type X6.5 and press NO. SRH. And remenber. Hyundai-Kia machines has the ladder open. It´s possible you edit that.

Good Luck,

Daniel

[jlviloria@gmail]

Good morning,

Friend apology but the truth do not know if I understood.

is that I am Colombian and I do not speak or write English, but the problem is that the X-axis moves slowly in a positive sense and in the negative moves fast

because if the solution to that problem is no excuse but to understand

as publishers that parameter in the machine?


jorge

[jlviloria@gmail]

I found this following the path you told me.

X0006 5
exdexl
0

ME THAT INDICATES THAT?

[xavierdemoura]

Jorge,

The limit switch of reference of the X axis are broken. Check that. The signal must stay in 1 when the axis is out of reference position.

Daniel