Fanuc O-T Series B

[yarpo]

Hi,
I've recently aquired a Colchester Tornado Lathe with the Fanuc O-T Series B controller. It's a 1996 machine and had a hard life!!

However, as with most older machines I didn't get any manuals....
Does anyone have an manual for the controller or a programming manual I could look at so I can run a few programs to see how accurate the machine is and to see if it's worthwhile spending a few quid on it...

many thanks,

Yarpo

[guhl]

Hi
Send your email address to my PM. I'll send to you operator's manual.