Need Help! RS232C Communication to Power Mate - CNCzone.com-The Largest Machinist Community on the net!

09-05-2008, 10:20 AM

bitwise

Join Date: Sep 2008

Location: USA

Posts: 1

RS232C Communication to Power Mate

permalink

I would like to send a Z axis setup value 12.1234 to memory location 500 in a Power Mate controller.

I have written a communication program that can talk over the RS232 port and send either EIA or ISO tape formatted data to the Power Mate controller.

I understand that there is a pop open command in the Power Mate controller but that is all I know.

Does anyone know how to write a routine in the Power Mate that will send a prompt out the RS232C port and then I can key on that prompt and send my setup value to the Power Mate.

I need this data to go to memory address 500.

Thank you.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Alarm 110 on Power Mate Model D/H	AZDEN	Fanuc	8	05-05-2008 08:09 AM
Problem- Power-Mate Model D	iNUC	Fanuc	1	04-19-2008 10:20 AM
Power Mate D	Bluesman	Fanuc	1	05-11-2007 06:53 PM
Fanuc Power Mate	Bluesman	Fanuc	1	01-02-2007 02:30 PM
Fanuc Power mate D	M.RISHIKESH	Fanuc	0	12-04-2006 10:28 AM

All times are GMT -5. The time now is 05:33 PM.