Need Help!- EDITING WITH FANUC LADDER III

[CHAD LAWSON]

I am writing ladder on Fanuc Ladder iii for a cincinatti FTV 850/1800 with an 18imb control and have run into trouble with inserting a sub timer. It tells me there is not enough room on that line, I also need an coil contact after the timer. I have seen in other ladders where they run one line into the next and have not found the cammand to do so. I have some experience writing for Allen Bradley slic 500s but am finding Fanuc Ladder software to be some what different.

[PMT]

The timer needs to be far enough left to fit on the line. I believe you can have 2 contacts before it. Perhaps you could write your logic on another line bringing up one contact to activate the timer.

[mluqman]

Hello, maybe this link could be useful for Ladder III FAQ http://cncfanuc.blogspot.com