| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-12-2008, 06:47 PM
| |||
| |||
I am new to this site and all forums for that matter but i need some help i have been running & programming lathes for about 4 years. I am writing a new programme in the 21t-i and need the code for SET & maximum Spindle speed Last edited by Jami9104; 06-12-2008 at 10:16 PM.  |
|
#2
06-12-2008, 11:02 PM
| ||||
| ||||
| G50 S1000 would temporarily cap the spindle speed at 1000rpm. The 'real maximum' is actually set in parameters somewhere.
__________________ First you get good, then you get fast. Then grouchiness sets in. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- G-code speed smoothing | meanshapes | G-Code Programing | 2 | 06-08-2008 12:33 AM |
| G-Code --- full speed | BeerFizz | Mach Mill | 17 | 12-08-2007 08:06 PM |
| fanuc 16i-m high speed G code ??????? | ramazan318186 | Fanuc | 1 | 07-23-2007 11:08 AM |
| Spindle Speed | wildcat | Industrial Hobbies (Support forum) | 4 | 01-27-2007 10:40 PM |
| BPSeriesI / Centroid control- Spindle speed all out of whack with speed dial? | peter.blais | Bridgeport and Hardinge Mills | 9 | 08-08-2006 03:29 AM |
| | |
Linear Mode
