| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-21-2008, 07:50 AM
| |||
| |||
I am new to CNC control, especially Fanuc controllers. I just started a job where there are 2 welding robots. One has a R G2 controller and one has an R J3 controller. I notice that both of these controllers have what appear to be 25 pin serial ports on the front. Can these be used for programing/parameter editing? Are the protocol/commands for the serial ports in the manual somewhere? Both of these controllers have hand held terminals hooked to them, but it seems like it would be nice to be able to use a PC to do backups, programming, etc.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CNC Controllers | ronald44 | Mechanical Calculations/Engineering Design | 1 | 11-14-2006 07:00 PM |
| use for controllers | don_harby | Fanuc | 3 | 03-02-2006 08:14 AM |
| pic controllers | DrStein99 | PIC Programing / Design | 2 | 01-17-2006 12:00 PM |
| Controllers which? | drakesis | Stepper Motors and Drives | 9 | 04-04-2005 05:35 AM |
| Controllers ? | Ken_Shea | General CAM Discussion | 23 | 05-25-2004 11:51 AM |
| | |
Linear Mode
