need a little help with drives for GE servo motors - CNCzone.com-The Largest Machinist Community on the net!

04-24-2008, 07:06 PM

panaceabea panaceabea is offline

Join Date: Aug 2004

Location: us

Posts: 309

need a little help with drives for GE servo motors

permalink

Could a couple of folks here familiar with GE servo motors take a look at this thread and give advice on the proper drives for these brushless AC servos? they are on a 30hp mhp lathe that was originaly fitted with a fanuc controller

http://www.cnczone.com/forums/showthread.php?p=443881

Last edited by panaceabea; 04-24-2008 at 07:48 PM.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Keling motors & drives	cut more	Automation Technology Products	95	12-13-2011 07:47 AM
Ultra PDM drives and motors	Hood	Servo Motors and Drives	0	03-13-2008 04:01 PM
Automation Direct/ Sure servo drives/motors	kmcwhq	Servo Motors and Drives	0	02-21-2007 06:49 PM
WANTED: Digital brushless servo drives and motors	rpseguin	Servo Motors and Drives	3	11-02-2006 08:19 PM
Servo motors, Drives	Wolfe	General Electronics Discussion	1	11-16-2003 01:47 PM

All times are GMT -5. The time now is 05:28 PM.