| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-03-2008, 01:39 PM
| ||||
| ||||
I just hooked up an RS-232 cable to an hold hardinge superslant with GN6T-C control. I was able to punch the program to my computer fine, however I keep receiving an alarm when I try to send from my computer to the control. The alarm states, number of bits of input data does not match or baud rate is incorrect. I have tried every baud rate from 110 to 4800. Can someone explain what is going on here. If this is in the wrong forum, my apologies in advance.  |
|
#3
04-03-2008, 01:56 PM
| ||||
| ||||
| I am using BobCad currently. There are separate settings for send & receive. I have the manual for this machine, but the section dealing with communications is missing. Luckily, I did have the section on setting up the cable, so I know that's right. I may have gotten lucky with the settings on punching it to my computer. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Comm Port Question | mepren1 | General Metal Working Machines | 1 | 02-26-2008 06:04 PM |
| VB 6 Comm PIC Processor | frog | Visual Basic | 0 | 02-12-2008 07:16 PM |
| comm 1 is out help please | dcrblazer | Milltronics | 0 | 04-16-2007 10:26 AM |
| PC to Brother TC-211 Comm Problem | Ben Colby | Mazak, Mitsubishi, Mazatrol | 1 | 03-31-2007 11:33 PM |
| Comm Cable | EvilScooby | General Electronics Discussion | 3 | 07-03-2003 06:16 AM |
| | |
Linear Mode
