| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-04-2008, 07:49 AM
| |||
| |||
I purchased an old ( late 80s ?) NEF 480 Lathe. It has a dead i/o board. will not power up. when I powered up the machine, the power section ( main resistors/diodes etc where power comes in) got very hot- the main resistor (white ceramic) was glowing :-( - I would like to get the machine working in it's original form but will consider updating the controls. Any one up for a challenge? Willling to hire a tech to come in an do an evaluation. I'm in Los Angeles...  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gildemeister CNC-Lathe NEF 480 | pestana1957 | General Metal Working Machines | 1 | 09-01-2010 12:48 PM |
| gildemeister lathe | roni21702 | Machine Problems, Solutions , Wireless DNC, serial port | 2 | 03-08-2010 11:09 AM |
| CNC lathe Gildemeister NEF 480 | pestana1957 | General Metal Working Machines | 2 | 05-17-2008 08:34 PM |
| Gildemeister Ctx310 | Camilla | Tahlcam | 0 | 10-23-2007 02:47 PM |
| on Gildemeister speed 12 -7 hard material machining | Ashu | Hard and High Speed Machining | 0 | 10-16-2006 07:14 AM |
| | |
Linear Mode
