DR SIGNAL OFF - CNCzone.com-The Largest Machinist Community on the net!

mustafaguler · #1 02-15-2008, 12:35 AM

Hi
I've got a Dahlih vertical milling machine with Fanuc 18M unit I transferred program from pc to machines HDD succesfully and puch the program start button and 086 DR SIGNAL OFF alarm please help me whats that

dcoupar · #2 02-15-2008, 10:26 PM

You need to jumper pins 6-8-20 on the CNC end of the cable. This should cure the alarm.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
No Output Signal	tz1238	Machines running Mach Software	1	01-27-2008 02:57 PM
end of bar signal	positiverake1	Daewoo/Doosan	4	08-24-2007 07:34 PM
Getting analog signal from pc	roni21702	Computers and Networking	1	06-15-2006 01:34 PM
Using the err signal	FrankdB	Servo Drives	1	03-30-2005 06:10 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)