| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Fanuc Discuss Fanuc controllers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-09-2008, 10:37 AM
| |||
| |||
Hello, I get an edit rejected error when I try to punch out my parameters. Does anyone have an experience with this error. I looked through my manual but did not see anything on it. I believe it has come up with the mdi functions insert, edit etc. thanks Sean  |
|
#2
01-09-2008, 05:26 PM
| |||
| |||
Possible edit rejected problems on punching out are, not being in the correct mode, Edit, program lock key in the wrong position. These are the norm, if this doesn't help, let us know the control type and I will try and jog my memory a bit more. Search the forum (Fanuc) for comms problems, lots of helpful tips/advice there gem |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Post edit help? | yanzeek | Surfcam | 12 | 09-03-2009 09:28 AM |
| Rejected part because of Servo fault?No more! | kolokithas | DeskCNC Controller Board | 7 | 02-19-2008 10:53 PM |
| Cimco Edit | alain aleman | Haas Mills | 2 | 06-14-2007 05:44 PM |
| Can't edit on OT fanuc!!! | steedspeed | General CNC (Mill and Lathe) Control Software (NC) | 17 | 06-04-2007 11:04 AM |
| | |
Linear Mode
