Results 1 to 2 of 2

Thread: CHECKING

  1. 12-23-2007, 07:07 AM #1
    CHANDRU
    CHANDRU is offline
    Registered
    Join Date
    Jan 2007
    Location
    INDIA
    Posts
    118
    Downloads
    0
    Uploads
    0

    CHECKING

    HEI FRIENDS,

    HOW TO CHECK THE FOLLOWING

    MT-PC

    PC-PC

    PMC-CNC

    CNC-PMC

    IN OLD FANUC CONTROLS LIKE 6T/6M,FANUC-MODEL OTA ETC.


    THANKS,

    CHANDRU

  3. 12-24-2007, 08:48 PM #2
    Jung
    Jung is offline
    Registered
    Join Date
    May 2005
    Location
    VietNam
    Posts
    103
    Downloads
    0
    Uploads
    0
    Look at diagnotics ... You need the maitenance manual.

« Fanuc 6t parameter #0-5 and #300-304 | Fanuc 21B board? »

Similar Threads

  1. Looking for NC checking software...
    By Jesusbot in forum General CNC (Mill and Lathe) Control Software (NC)
    Replies: 5
    Last Post: 06-03-2012, 11:01 PM
  2. Checking for a bad motor.
    By impact in forum General Electronics Discussion
    Replies: 0
    Last Post: 08-09-2007, 05:29 PM
  3. checking accuracy
    By DEW in forum General Waterjet
    Replies: 2
    Last Post: 10-01-2005, 10:27 AM
  4. Double Checking!!
    By chas in forum Gecko Drives
    Replies: 4
    Last Post: 04-12-2005, 12:38 AM
  5. Newbie checking in.
    By jstuedle in forum DIY CNC Router Table Machines
    Replies: 10
    Last Post: 06-30-2004, 11:58 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.